FTO Drivers Club, Western Australia

monsterbishi · Posted: Sat Dec 17, 2005 4:46 am Post subject: GPX Ecu pinout

Hi All,

Just dug up this site from google, I'm hoping there's someone here who can help answer my question, I've already done a few searches within your forum, and on your website, but to no avail.

Anyway, I'm after a complete pinout of the FTO's ECU, and the pinout for the ignition harness connector that is next to it under the dash, so I can finish off the wiring in a project I'm helping build.

We're building a Rally car for the 06 season over here in New Zealand, namely in the Kiwi2 class, FWD NA, it's a 97 Mirage 2 door, running a GPX Mivec engine/gearbox, with a scratch built wiring system to be as light as possible, so we don't have a reference car to work off for the ignition layout.
_________________
--- Cut Here ---
'94 Mustang GT Coupe

RichardH · Joined: 27 Jan 2003 Posts: 804

Best of luck with the project!

Your best bet is to download the full workshop manuals from FTO Ireland website:

http://www.fto-ireland.com/downloads.html

The "Electrical" manual has engine ECU external wiring diagrams, ie. pinouts. Just what you're after...

- Rich

monsterbishi · Posted: Mon Dec 19, 2005 9:41 am Post subject:

Cheers, I already have that document, ideally we're after a straight pinout for the ecu connectors, so far the 2nd gen 4g92 mivec setup that some Mirages used seems to match up though.
_________________
--- Cut Here ---
'94 Mustang GT Coupe

monsterbishi · Posted: Fri Dec 23, 2005 7:04 pm Post subject:

ok, ecu end of things is pretty much done, the 4g92 mivec pinout is indeed almost identical to the fto's so that was easy work.
_________________
--- Cut Here ---
'94 Mustang GT Coupe